The Kryptonian inscription on the Heart translates as "Jor-El" and Kal-El. This device appears to activate the craft's memory banks where pre-recorded messages are stored. They are a flawed race. Rule them with strength, my son. That is where your greatness lies.
The Heart has been 3D printed in parts out of Photosensitive resin in two parts before being assembled. The clear part has been sanded to a fine grit, and then finished with an automotive clear coat to give it a glass like finish. The base part has been sanded, painted in silver, and golden vinal decals added before the part is also finished with an automotive clear coat. The stand has been 3D printed in clear Photosensitive resin which has been given a clear coat to give it a crystalline appearance. A small LED light setup has been included in the stand to illuminate the model and give it a mesmerising glow.100mm X 10mm X 197mm (3.97in X 0.39in X 7.76in). Set size when assembled approx. 138mm X 94mm X 214mm (5.456in X 3.69in X 8.45in). Crystal and stand are original model designs. Sent with Australia Post Standard Service. If there are specific problems with your postal destination I will contact you to plan a way ahead.